This exciting tube distortion pedal gives you the warm tube crunch that you can only get from tubes. Although the Markbass Distorsore gives you access to a wide range of tones, it always honors the basic character of your instrument by adding tube distortion to the clean sound of your bass. Clean controls your input level; Tube controls the intensity of the distortion; and Mix lets you choose the balance between the clean and the distorted signals. 

Since distorting bass frequencies can seriously muddy your low end sound, Markbass Distorsore pedal features a very practical filter for bass in the High Pass. It allows you to only distort the high frequencies. This keeps your sound tight and focused, no matter how distorted you get. As you turn this knob up, a wider range of low frequencies is kept clean, so you are only distorting the high frequencies and keeping your bottom end full and tight. This produces rich harmonics and exciting distortion, but every note remains distinct and focused and the natural tone of your instrument still shines through. 

The Markbass Distorsore features a direct balanced XLR output (with ground lift) that allows you to also use the bass pedal as a DI box, sending your (post effect) signal straight to a mixing board or balanced XLR soundcard input. Like all Markbass pedals, this one features true bypass, which means that when the distortion is off, your signal goes directly from the input jack to the output jack without any degradation of audio quality.

Markbass Distorsore Bass Pedal Features:

• CONTROLS
• Gain
• Volume
• Comp
• Tube drive
• Low pass
• High pass
• Mix
  
  REAR PANEL
• Input jack
• Output jack
• Power jack (DC 12V)